Mower Attachment
TBD: Add make and model
Specifications
| Spec | Value |
|---|---|
| Make/Model | TBD |
| Type | Flail / Rotary / Finishing |
| Cutting width | TBD |
| PTO speed | TBD |
| Storage location | TBD |
Uses
- Paddock maintenance
- Grass cutting
- Rough area clearing
- Pasture topping
Pre-Use Checks
- Inspect blades/flails for damage or wear
- Check belt tension (if belt-driven)
- Check PTO shaft and guards
- Ensure all guards in place
- Check for debris in cutting chamber
Attachment Procedure
See general attachment procedure, plus:
TBD: Add specific connection instructions
Operation
- Attach to tractor following procedure
- Set cutting height before starting
- Start tractor, engage PTO at low RPM
- Increase to operating RPM
- Lower mower to cutting position
- Drive at appropriate speed for conditions
Cutting Tips
- Adjust speed based on grass density
- Overlap passes slightly
- Avoid scalping on uneven ground
- Raise mower when turning
- Stop PTO before reversing
Hidden Hazards
Walk the area first to check for rocks, stumps, wire, or other hazards that could damage the mower or become projectiles.
After Use
- Disengage PTO and turn off tractor
- Lower mower to ground
- Remove debris from cutting deck
- Inspect blades for damage
- Grease fittings if required
Maintenance
| Task | Frequency |
|---|---|
| Inspect blades | Before each use |
| Clear debris from deck | After each use |
| Check belt tension | Weekly |
| Sharpen/replace blades | As needed |
| Grease fittings | As per manual |
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Uneven cut | Blades dull or damaged | Sharpen or replace |
| Deck not level | Adjust deck height | |
| Excessive vibration | Blade out of balance | Replace blade |
| Debris wrapped on spindle | Clear debris | |
| Won’t engage | PTO issue | Check PTO connection |
| Belt broken/slipping | Replace/tension belt |
Storage
- Clean thoroughly before storage
- Store under cover
- Check for rust/corrosion periodically
- Location: TBD